Bowl of Mice
My Little Bit of Cyberspace
Removing the underseat exhaust.
Pull the link pipe and twist it gently at the same time and
remove it, the heat shield and the mesh gaskets as a single
Undo the small bolt holding the top of the link pipe in place
Pull the end can downwards and than backwards to disengage
the two pegs on the front from the rubber grommets.
If there is a grab rail, remove that and then remove the bolt
securing the end can to the seat mounting
And undo the clamp securing the link pipe to the downpipe
This only shows how to remove the link pipe and the end can.
The downpipes pretty much dont ever need removing unless
you are dropping the engine out.
Under the seat, unto the exhaust clamp that joins the end can
to the link pipe
And thats it.